• 论文
主办单位:煤炭科学研究总院有限公司、中国煤炭学会学术期刊工作委员会
高温作用后2种层理砂岩的动态力学试验及细观分析
  • Title

    Dynamic mechanical behavior and mesoscopic analysis of two layered sandstone after high temperature

  • 作者

    顾超许金余孟博旭闻名娄传鑫

  • Author

    GU Chao1 ,XU Jinyu1,2 ,MENG Boxu1 ,WEN Ming1 ,LOU Chuanxin1

  • 单位

    空军工程大学 机场建筑工程系西北工业大学 力学与土木建筑学院

  • Organization
    1. Department of Airfield and Building Engineering,Air Force Engineering University,Xi’an  710038,China; 2. College of Mechanics and Civil Architecture, Northwest Polytechnic University,Xi’an  710072,China
  • 摘要

    为研究层理岩石的动态力学和细观结构方面的各向异性特征,利用大直径(ϕ100 mm)分 离式霍普金森压杆(SHPB)系统,进行高温作用后层理砂岩的动态压缩试验,而后对试件破坏断口 进行 SEM 电镜扫描试验,分析其断口形貌特征与能耗规律,并对提取出的微裂缝网络进行数值分 析。 试验结果表明:高温作用后各向异性砂岩的动态力学性能受冲击弹速、温度效应、层理各向异 性的共同影响,随着冲击弹速的增加,砂岩的峰值强度逐渐增加,峰值应变逐渐增大,变形模量也逐 渐增加;随着温度的升高,砂岩的峰值强度逐渐减小,峰值应变逐渐增大,而变形模量逐渐减小;平 行层理砂岩的峰值强度、峰值应变和变形模量普遍高于垂直层理岩样,整体性更好。 层理砂岩在高 应变率下破坏的断口表面比在低应变率下整体度差,形貌更加粗糙。 经历温度不大于 400 ℃时,断 面以沿晶破坏和穿晶破坏为主,表现为脆性断裂;经历温度为 800 ℃时,除前 2 种断裂模式外,断面 局部还出现塑性破坏和韧性破坏特征。砂岩在高应变率下破坏时能耗普遍高于低应变率破坏。 断 口裂隙的数量、裂隙的面积、裂隙的形状三者均存在明显的各向异性差异,水平层理的裂隙数量普 遍高于垂直层理;水平层理岩样的微观裂隙率曲线低于垂直层理岩样;垂直层理的裂隙形状普遍比 水平层理规则。 高温处理后岩样动态破坏断口的裂隙形态趋于规则。

  • Abstract

    In order to study the anisotropic characteristics of layered sandstone in dynamic and meso-structure,dynamic compression of layered sandstone after high-temperature heating was tested by large-diameter ( ϕ100 mm) SHPB. Then the fracture surfaces were tested by the scanning electron micro-scope ( SEM) so as to analyze the features of fracture morphology as well as the law of energy consumption and to conduct the numerical analysis of the extracted micro-crack network. According to the test results,the dynamic mechanical properties of anisotropic sandstone after high temperature are affected by the velocity of impact bullet,temperature effects and bedding anisotropy. As the veloc-ity of impact bullet rises,the peak intensity of sandstone increases,peak strain increases,and variable model increa-ses. As temperature rises,the peak intensity of sandstone decreases,peak strain increases,while variable model decrea-ses. Parallel layered sandstone shows a better integration than vertical samples in terms of peak intensity,peak strain and variable model. Fractures under high strain rates show a worse integration than the ones under low strain rates, with a rougher morphology. With a temperature under 400 ℃ ,the fractures mainly consist of inter-granular fracture and trans-granular fracture,presenting brittle fracture. With a temperature of 800 ℃ ,fractures partially present plastic frac-ture and ductile fracture,apart from the two former modes. The energy consumption of broken sandstone is higher un-der high strain rates than that under low strain rates. There is obvious anisotropy among numbers,areas and shapes of fractures. In general,the fracture number in horizontal bedding samples is more than that in vertical bedding samples. The micro-fracture rate curve of horizontal bedding samples is lower than that in vertical bedding samples. Fracture shapes in vertical bedding samples are generally more regular than those in horizontal bedding samples. Fracture shapes of dynamic broken samples after high temperature tend to be regular.

  • 关键词

    岩石力学高温作用各向异性动态力学断口分析

  • KeyWords

    rock mechanics;high temperature action;layered sandstone;dynamic mechanics;mesoscopic analysis

  • DOI
  • Citation
    GU Chao,XU Jinyu,MENG Boxu,WEN Ming,et al. Dynamic mechanical behavior and mesoscopic analysis of two layered sandstone after high temperature [ J]. Journal of China Coal Society,2019,44 ( 9 ):2710 - 2720.
  • 相关专题
  • 图表
相关问题

主办单位:煤炭科学研究总院有限公司 中国煤炭学会学术期刊工作委员会

©版权所有2015 煤炭科学研究总院有限公司 地址:北京市朝阳区和平里青年沟东路煤炭大厦 邮编:100013
京ICP备05086979号-16  技术支持:云智互联